Product Description
Different blade installation methods can obtain different tillage effects. Blade installation is divided into three kinds: first, the common blade installation mode, this arrangement mode after the surface is flat, suitable for flat tillage; The second is the installation mode of rotary tilling-ditching joint operation. This arrangement method forms a shallow ditch in the middle of the field after tilling, and the soil blocks are thrown to both sides to facilitate the middle ditching operation. The third is the bed blade installation mode, when the machine is rotating tillage across the ditch, some soil blocks are thrown into the ditch to achieve the role of filling the ditch. When rotating tillage is performed, appropriate blade installation methods should be selected according to different agronomic requirements.
02. Installation of universal-joint drive shaft
The universal joint rotating shaft is composed of two joints, and two points should be paid attention to when installing: first, when the rotary tiller is rising or working, the square shaft and the sleeve should not be top dead, but also have enough matching length; The second is that the square shaft and the fork of the sleeve must be in the same plane, so as not to affect the quality of operation and cause damage to the tractor and rotary tiller transmission system and related parts.
Detailed Photos
Product Parameters
| A variety of specifications rotary tiller |
| Gasoline engine diesel power |
Left and right horizontal adjustment. The tractor is parked on the ground, and the rotary tiller is lowered so that the blade tip is close to the ground, to see whether the height of the left and right blade tips from the ground is consistent. If not, the left and right lifting rod of the tractor suspension mechanism can be adjusted to make the rotary tiller in a horizontal state to ensure that the left and right ploughing depth is consistent.
Adjusting the Angle between the front and back of the universal joint. When the rotary tiller is lowered to the required ploughing depth, see whether the front and back clamps of the universal joint assembly are horizontal, whether the Angle is small, and whether the front and back angles are equal. The method of adjusting the length of the upper tie rod can ensure that the Angle of the universal joint is small, so that it is in a very favorable working state
Tillage depth adjustment. The tillage depth is adjusted by the lifting clamp of the hydraulic suspension mechanism. In order to ensure the same tillage depth when the rotary tiller is operating, the positioning handwheel can block the adjusting handle or adjust the positioning clamp on the cylinder piston rod properly and fix it
Rotary tiller lifting height adjustment. Since the Angle of the universal joint should not be too large, generally, as long as the tip of the knife is 20cm from the ground when turning and lifting, you can turn empty without cutting off the power output, such as when the ditch or road transportation needs to be lifted to a higher position, the power must be cut off. When working in the field, it is required to set the lifting height position limit, and fix the limiting screw at the appropriate position on the adjusting fan plate in place, so that the adjusting handle is in the same position every time when lifting, to achieve the same lifting height.
){kind=link}